AEG FD395V User Manual page 35

How to set the water softener
level
Make sure the appliance is in user mode.
1. Wait until the indicator
flash, the indicator
to flash and the remaining indicators
are off.
The intermittent flashing of the indicator
shows the current setting: e.g. 5
flashes + pause + 5 flashes = level 5.
2. Press the programme button
repeatedly to change the setting.
Each pressing of the programme
button increases the level number.
After reaching the level 10, the count
starts again from the level 1.
3. Press the on/off button to confirm the
setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains. It is
automatically released during the hot
rinse phase.
When the rinse aid chamber is empty,
the rinse aid indicator is turned on
notifying to refill rinse aid. If the drying
results are satisfactory while using multi-
tablets only, it is possible to deactivate
the notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
Make sure the appliance is in user mode.
1. Press the programme button
immediately.
The indicator starts to flash.
2. Wait until the indicator
to flash and the remaining
programme indicators are off.
The indicator
setting:
•
starts to
•
continues
3. Press the programme button to
change the setting.
4. Press the on/off button to confirm the
setting.
6.4 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic signal
is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of the
programme
Make sure the appliance is in user mode.
1. Press the programme button twice.
The indicator
2. Wait until the indicator
to flash and the remaining
programme indicators are off.
The indicator
setting:
•
•
3. Press the programme button to
change the setting.
4. Press the on/off button to confirm the
setting.
6.5 AirDry
AirDry improves the drying results with
less energy consumption.
continues
shows the current
is on = Rinse aid empty
notification is on.
is off = Rinse aid empty
notification is off.
starts to flash.
shows the current
is off = The acoustic signal is
off.
is on = The acoustic signal is
on.
ENGLISH 35
continues