Scandomestic SKF 327 W User Manual page 20

are recycled.
The refrigerants used in your equipment and insulation materials require special handling procedures. Make sure there is
no pipe damage on the back of the equipment before handling.
Up-to-date information on the options for disposing of old equipment and packaging from old equipment can be obtained
from the local municipal office.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or contact the retailer where
the product was purchased. They can take this product for environmental safe recycling.
War nings for disposal
※
Refrigerant and cyclopentane foaming material used for the refrigerator are flammable.
Therefore, when the refrigerator is scrapped, it shall be kept away from any fire source and be
recovered by a special recovering company with corresponding qualification other than be
disposed by combustion, so as to prevent damage to the environment or any other harm.
※
When the refrigerator is scrapped, disassemble the doors, and remove gasket of door and
shelves; put the doors and shelves in a proper place, so as to prevent trapping of any child.
Reversing the Door Swing
1. Make sure that your refrigerator is unplugged.
2. Pry the hinge cover up and off, remove the three
screws that secure the upper hinge to the door, then
remove the hinge.
3. Remove the refrigerator compartment door from the
cabinet.
4. Remove the two screws that secure the center hinge.
5. Remove the freezer compartment door.
6. Remove the screws that secure the lower hinge to the
right side of the cabinet, then remove the hinge.
7. Remove the washer and nut that secure the pin shaft to
the right hole on the lower hinge, then remove the shaft
8. Insert the pin shaft into the left hole on the lower hinge,
then secure the shaft with the washer and nut.
9. Install the lower hinge on the left side of the cabinet.
10. Remove the screw that secures the door stop from the
bottom right of the freezer compartment door, then
remove the door stop and install to the bottom left side.
11. Install the freezer compartment door.
12. Move the door bushing from the top right side of the
freezer door to the top left side of the door. And move the
left hole cover to the right side.
13. Remove the center hinge screw hole plug on the left
side of the cabinet, then install in the screw holes on the
right side of the cabinet.
14. Install the center hinge to the left side with the two
screws you removed previously.