Electrolux GA60SLVC User Manual page 25

Problem and alarm code
You cannot activate the
appliance.
The programme does not
start.
The appliance does not fill
with water.
The display shows
ror i10 or Error i11 and
No intake of water.
The appliance does not
drain the water.
The display shows
ror i20 and Water is not
draining.
The anti-flood device is on.
The display shows
ror i30 and Risk of flood
detected.
Malfunction of the water
level detection sensor.
The display shows i41 -
i44.
Malfunction of the wash
pump or the drain pump.
The display shows i51 -
i59 or i5A - i5F.
The temperature of the wa‐
ter inside the appliance is
too high or malfunction of
the temperature sensor oc‐
curred.
The display shows i61 or
i69.
Technical malfunction of
the appliance.
The display shows iC0 or
iC3.
Possible cause and solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for
the end of the countdown.
• The appliance recharges the resin inside the water
softener. The duration of the procedure is approxi‐
mately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
, Er‐
water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clog‐
ged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clog‐
ged.
, Er‐
• Make sure that the drain hose has no kinks or bends.
• Close the water tap and contact an Authorised Serv‐
ice Centre.
, Er‐
• Make sure that the filters are clean.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the temperature of the inlet water
does not exceed 60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
ENGLISH 25