Troubleshooting - Pro-Line Boats VS-D2 User Manual

TROUBLE SHOOTING
BEFORE YOU EMAIL FOR SERVICE PLEASE REVIEW THE TROUBLE SHOOTING TIPS FIRST.
Problem
Nothing happens when I
press the vacuum sealer
Air is not removed from the
bag completely
16 INSTALLATION AND OPERATING INSTRUCTIONS
Possible Cause
1. Power cord is not plugged in.
2. Power cord is damaged.
1. The bag has not been placed correctly
inside the Vacuum Chamber.
2. Debris covering sealing strip or upper
and lower gaskets. Sealing strip gaskets
may be out of place.
3. Bag may have a hole.
4. Unit cover has not been closed properly.
Solution
1. Make sure the power cord is correctly plugged into the
electrical outlet, and in the "on" position.
2. Check power cord and plug, and make sure they are
not damaged in any way. If damaged, do not use the
vacuum sealer.
1. To seal properly, open end of bag should be resting
entirely inside the Vacuum Chamber.
2. Check Sealing Strip, Upper Gasket and Lower Gasket
for debris. Ensure Gaskets are correctly sealed and
are not compressed. See page 15 for further
information on Gaskets.
3. To test, seal the bag with some air in it, submerge
in water, and apply pressure. If there are bubbles
present, it does indicate a leak and a new bag should
be used.
4. Open cover and re-close the cover. Push down firmly
on the cover until you hear it 'click' indicating the cover
is now fully closed and locked in.