Dell PowerVault 720N Installation And Troubleshooting Manual page 64

3-12 Dell PowerVault 720N, 740N, and 760N Installation and Troubleshooting Guide
*Env-B rupt err
*Env-C rupt err
*FP button stuck
*FLPY init fail
*FLPY reg error
If the hardware passes all POST tests, the filer begins to load the filer software and
display informational boot messages.
Figure 3-7 shows a sample message that appears on the system console when the
filer is successfully started. The exact boot messages that appear on your system
console depend on your system configuration.
If you are starting the system from a system boot diskette, some messages might be
different from the following messages. Refer to the Dell PowerVault 720N, 740N, and
760N System Administrator and Command Reference Guide for information about
how the filer is started from a system boot diskette.
NetApp Release 5.3: Fri Apr 23 14:57: 51 CDST 1999
System ID: 0016788685 ()
slot 0: System Board
Memory Size:
slot 0: Fibre Channel adapter
Version 1.12
Host Loop Id 119
Cacheline size 8
3 Disks:
1 shelf with DISK ENCLOSURE
SCSI Host Adapter 0b
slot 0: Ethernet Controller e0
MAC Address: 00:a0:98:00:3b:71 (auto-100tx-fd-
up)
slot 3: Ethernet Controller e3
MAC Address:
slot 9: NVRAM
Memory Size:
Please enter the new hostname [ ]:
512 MB
FC Packet size 2048
25.8GB
00:a0:92:f7:62:56 (tp-down)
32 MB