Dell PowerVault 720N Installation And Troubleshooting Manual page 49

To connect an ASCII terminal to the filer, perform the following steps:
1. Ensure that the terminal settings match the filer's, listed in Table 2-8.
Line speed
Data bits per character
Parity
Stop Bits
Flow Control
Refer to the documentation for your terminal for further details.
2. Connect the cable's socket end to the filer's plug connector, labeled CONSOLE.
Use the provided DB-9–to–DB-9 serial cable.
Figure 2-13 shows the location of the CONSOLE port.
If you are connecting an ASCII terminal from a remote site, be sure that you do not
have a local terminal connected to the filer's CONSOLE port.
9600 baud
8
None
1
None
Console port
Installing a Filer System 2-19