Connectors & Jumper Settings - Infinite AERINOS ADS-260 User Manual

3.3 Connectors & Jumper settings
3.3.1 LED
D13: Status LED, Blinking in configuration mode.
3.3.2 Connectors
JMP1: Put a Jumper to enter configuration mode.
J2: USB Serial connector. The unit can be supplied through the USB connector for
configuration and test.
Caution: Remove the external power supply (J5-1), if applied, before connecting
the USB connector!
J4: Battery connector.
J5-1: VCC, External power supply, 5V (stabilized).
J5-2: 12VDC sensor excitation (switched)
J5-3: 5VDC sensor excitation (switched)
J6-1: GND (COM), Common for IN1
J6-2: SDI-12 data line
J6-3: RS-485 bus (-)
J6-4: RS-485 bus (+)
J6-5: IN1, Multifunction Input (Digital, Analog, Counter: software selectable)
3.3.3 Switches
S1: Test mode button
ADS-260 User Guide 6