Connecting The Water Inlet Hoses - LG T2175VS2M Owner's Manual

Connecting the Water Inlet
Hoses
Before connecting the water inlet hose to the water
tap, check the hose fitting type and then choose
the correct instruction.
Note for Connection
• Water supply pressure must be between 50 kPa
and 800 kPa (0.5 - 8.0 kgf / cm²). If the water
supply pressure is more than 800 kPa, a
decompression device should be installed.
• Do not overtighten the water inlet hose to the
valve.
• Periodically check the condition of the hose and
replace the hose if necessary.
Checking the Rubber Seal
Two rubber seals are supplied with the water
a
inlet hoses. They are used to prevent water leaks.
Connection to taps is sufficiently tight.
• Do not use mechanical devices such as multi
grips to tighten the inlet hoses. Ensure that the
curved end of the water inlet hose is connected
to the appliance.
Connecting the Hose to the
Water Tap
1
Loose the 4 fixing screws .
a
2
Remove the guide plate
to fit the adapter.
3
Push the adapter onto the end of the tap so
that the rubber seal is connected to be
watertight. Tighten the 4 fixing screws.
4
Push the inlet hose
that the rubber seal within the hose can adhere
completely to the tap and then tighten the
hose by screwing it to the right.
NOTE
• After connecting the water inlet hose to the
water tap, turn on the water tap to flush out
foreign substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
INSTALLATION 11
if the tap is too large
b
vertically upwards so
c
EN