Listening To A Cassette Tape - Sharp CD-BK100W Operation Manual

Listening to a Cassette Tape

Before playback:
z For playback, use normal or low-noise tapes for the best sound.
(Metal or CrO tapes are not recommended.)
z Do not use C-120 tapes or poor-quality tapes, as they may cause mal-
functions.
z Before loading a tape into the cassette compartment, tighten the slack
with a pen or a pencil.
Playback is possible in TAPE 1 compartment as well as in TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TAPE (1 2) button to select TAPE 1 or TAPE 2.
3
Open the cassette door by pushing the
area marked " PUSH EJECT".
4
Load a cassette into the TAPE 1 or TAPE
2 cassette compartment.
5
Press the / button to start playback.
When playback is performed using the remote control, press the TAPE 1 or
TAPE 2 button.
To stop playback:
Press the (TAPE ) button.
Fast forward/rewind: (TAPE 2 only)
1 Press the (TAPE ) button, then press the TAPE (1
2.
2 To advance the tape, press the
Caution:
z To remove the cassette, press the
ment.
z Before changing from one tape operation to another, press the
z If a power failure occurs during tape operation, the tape head will remain engaged
with the tape and the cassette door will not open. Wait until power is restored.
General Control (See page 10.)
2) button to select TAPE
button. To rewind it, press the button.
(TAPE ) button, and then open the compart-
(TAPE ) button.
ENGLISH
CD-BK100W
E-18