Dispenser - Thermador T18ID905RP Use & Care Manual

Dispenser

Ice is being produced and dispensed but no water.
Fault with the appliance.
Dispenser not working.
Controls for dispenser panel lock are locked (child lock).
Ice cubes may freeze together and block the dispenser or the ice
maker.
After switching on or removing many ice cubes, there will be too few
in the ice cube container.
Water tank is filling up.
Low water pressure.
The water filter/particle filter is blocked or needs to be replaced.
The ice maker is not functioning.
Ice cube production is switched off.
Freezer compartment is too warm.
Ice cube container is not properly inserted.
Ice maker without power.
No water supply.
Low water pressure.
Kink in water hose.
Too few or deformed ice cubes, water pressure lower than usual.
After switching on or removing many ice cubes, there will be too few
in the ice cube container.
Low water pressure.
The water filter/particle filter is blocked or needs to be replaced.
Freezer compartment is too warm.
Water is leaking out of the appliance.
Water connection is not tight.
--------
Call customer service.
~ "Customer service" on page 28
Unlock controls for dispenser panel lock.
Open the door. Check inside whether ice cubes are stuck in the
1.
dispenser.
If the dispenser is not blocked, carefully pull the ice cube container
2.
out.
CAUTION
A full ice cube container is heavy!Use both hands and proceed
slowly.
Remove the ice cubes which are frozen together.
3.
It takes around 24 hours for an empty ice cube container to fill up.
When used for the first time, the water tank takes around 2 minutes to
fill up.
Only connect appliance to pipes with sufficient water pressure.
Replace water filter / clean particle filter.
Switch on ice cube production.
Set the temperature lower.
~ "Operating the appliance" on page 14
Insert ice cube container fully.
Call customer service.
~ "Customer service" on page 28
Check water connection and contact technician if necessary.
Only connect appliance to pipes with sufficient water pressure.
Turn off water supply, straighten out kink. Replace water hose, if nec-
essary.
It takes around 24 hours for an empty ice cube container to fill up.
Only connect appliance to pipes with sufficient water pressure.
Replace water filter / clean particle filter.
Set the temperature lower.
~ "Operating the appliance" on page 14
Check if the connections are fastened firmly and the water hose is
undamaged.
If the water hose is damaged, contact customer service and have it
replaced. Replacement must be performed by customer service or a
similarly qualified person only.Use original parts supplied by the man-
ufacturer only.
Faults – what to do? en-us
27