Disposal - AWG M2 Original Operating Manual

AWG I Operating manual I Fittings I
Replacing the pressure gauge
1. Use a spanner A/F 14 to unscrew the pressure gauge (Fig. 3/3)
from the nozzle body.
2. Clean the female thread on the nozzle body.
3. Position the new pressure gauge on the shut-off valve and carefully
tighten until you feel a slight increase in torque.
Any repair work on the AWG Foam nozzles may only be performed by
the AWG Fittings GmbH customer service or by an authorised special-
ist workshop.
If you need technical support, please contact our Service Centre:
AWG Fittings GmbH
Service Centre
D-89177 Ballendorf
Telephone: +49 (0) 73 40 / 91 88 98 880
Email: awg-service@idexcorp.com
We will accept devices in need of repair or maintenance, discuss with
you the quickest and cheapest solution, create cost estimates, take
care of the execution of the repair work and are at your disposal for
any questions.
7.3

Disposal

Observe the local regulations regarding proper waste recycling or
disposal.
Materials
Foam tube, conversion screen:
Nozzle body, stop valve:
Seals:
Protection ring:
38 / 40
Medium expansion foam nozzles M2, M4, M8
Stainless steel
Aluminium
NBR
NBR
ENGLISH
MAINTENANCE
M1107B10 I Rev. 02-03/20