Ayce 0201 Original Instructions Manual page 16

Installation:
Note: This appliance is only intended for fixed installation. Follow the instructions in fig. 1.
Do not install this unit to the ceiling. Do not attach to a Stud. Do not attach to a surface subject
to vibrations. The halogen bulb in the housing would burn out prematurely if the housing installed
at an angle more than 4° .
Fig. 2
4. Check carefully whether the strain relief properly and use them appropriately.
5. Fix the cover by tightening to the junction box.
6. Fasten the floodlight with screws and bolts in the desired position. (Fig. 3)
2. Pull the cable through the gasket hole. Check carefully whether
the sealing opening in good condition is.
3. Connect the wires according fig. 2.
Fig. 3
16 | 17
Fig. 1
GB