Os/2 Client Driver; Server Drivers For Novell Netware Environments - Dell OptiPlex GXi Reference And Installation Manual

Chapter 6. Then connect the NIC expansion card
to its network.
4. Turn on the system.
5. When the Starting MS-DOS message is dis-
played, press
<F5>
or memory managers.
6. Insert the NIC driver diskette into drive A. Then
type a: and press <
7. Type install and press <
8. Select
CONFIGURATION AND DIAGNOSTIC PRO-
from the Main Menu.
GRAM
9. Scroll the list of NICs and find the integrated NIC
and the NIC expansion card you installed. Write
down the slot number and bus number for each.
10. Type the following commands and press
after each:
cd c:\nwclient
edit net.cfg
11. Find the following LINK Driver 3C90X sec-
tion in the file:
LINK Driver 3C90X
;
; BUS NN
; SLOT 7
12. Delete the semicolon from the BUS NN line and
replace NN with the bus number for the inte-
grated NIC.
Use the bus number you recorded in step 9.
13. Delete the semicolon from the SLOT 7 line and
replace 7 with the slot number for the integrated
NIC.
Use the slot number you recorded in step 9.
14. Copy the four modified lines shown in step 11 and
paste them below the original four lines. Then
modify the BUS and SLOT lines to reflect the bus
number and slot number for the NIC expansion
card.
15. Restart the system.
4-6 Dell OptiPlex GX i Low-Profile Systems Reference and Installation Guide
to prevent loading any drivers
>.
ENTER
>.
ENTER
<ENTER>

OS/2 Client Driver

NOTE: The OS/2 drivers are available from the Dell
BBS. See the chapter titled "Getting Help" in your Diag-
nostics and Troubleshooting Guide for the contact
number for your location.
Install the OS/2 client driver as follows:
1. Connect the integrated NIC to its network
according to the instructions in "Connecting to a
Network" found earlier in this chapter.
2. Exit to MS-DOS by doing one of the following:
•
Restart the system with a clean, bootable
MS-DOS diskette in drive A.
•
Type the following commands in an OS/2 win-
dow, pressing
<ENTER>
cd /os2
boot /dos
3. Insert the NIC driver diskette into drive A. Then
type a: and press <
4. Type install and press <
5. From the Main Menu, select
and press
AND UPDATE
6. From the Network Drivers menu, select
NOVELL NETWARE DRIVERS and
7. From the Novell NetWare Drivers menu, select
COPY OS/2 ODI DRIVER
8. If you want to copy the driver to c:\netware, press
. To copy the driver to another directory,
<ENTER>
type the path and press
Server Drivers for Novell NetWare
Environments
You can configure your system as a server computer
under either Novell NetWare 3.12 or 4.10. The drivers for
these network operating systems are located in the
\nw312 and \nw410 directories on the NIC driver dis-
kette. Instructions for installing and configuring these
drivers are contained in the help.exe program on the NIC
driver diskette.
after each:
>.
ENTER
>.
ENTER
DRIVER INSTALLATION
.
<ENTER>
INSTALL
press
<ENTER>
and press .
<ENTER>
.
<ENTER>
.