General safety precautions 10. Connect dust extraction equipment. If devices are provided for the connection of dust extraction and collection facilities ensure these WARNING! When using electric are connected and properly used. tools, basic safety precautions should always 11. Do not abuse the cord. Never carry the tool be followed to reduce the risk of fire, electric by the cord or yank it to disconnect it from the shock and personal injury, including the...
21. Warning Use only accessories or attach- ments recommended in this instruction manual or in the catalogue of ZENIT ТМ. Model JS-900 profi 22. Have your tool repaired by a qualified per-...
Page 5
When the work area is removed from the power cutting of stainless steel plates” for proper source. Use an extension cord of sufficient operation. thickness and rated capacity. The extension 8. Splinter guard cord should be kept as short as practicable. Using the splinter guard when cutting wood 4.
(1) Loosen the base bolt allen wrench attached part of the base with the [ ] mark on the gear on base. cover. (2) Move the base fully forward, and tighten the (3) Tighten the M5 bolt again. base bolt again. (4) Set the orbital position to “0”.
Page 7
3. Maintenance of the motor. WARNING! Repair, modification and The motor unit winding is the very “heart” of check of ZENIT power tools should be the power tool. Exercise due care to ensure the performed only in authorized service centers winding does not become damaged and/or wet ZENIT.