Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zenit JS-1050M
Summary of Contents for Zenit JS-1050M
- Page 1 JIg saw Js-1050m InstructIon manual...
-
Page 3: General Safety Precautions
General safety precautions WARNING! When using electric tools, basic safety precautions should always be fol- lowed to reduce the risk of fire, electric shock and personal injury, including the following. Read all these instructions before operating this product and save these instructions. For safe operations: Keep work area clean. - Page 4 Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original ZENIT TM spare parts. Otherwise this may result in considerable danger to the user. safety precautions on using jig saw This Jig Saw employs a high-power motor.
-
Page 5: Technical Specifications
technical specifications Model Js-1050 M Rated voltage 220-240 V Rated frequency 50-60 Hz Rated power 1050 W Cutting depth: in wood 65 mm in metal 8 mm Cutting angle: 0-450 Speed 500-3000 spm applications Cutting various lumber and pocket cutting. Cutting mild steel plate, aluminum plate, and copper plate. - Page 6 5.1 Open the lever up to the stop. 5.2 Remove fitted blade 5.3 Insert new blade up to the stop in the blade holder 5.4 Close the lever CAUTION! Be sure to switch power OFF and disconnect the plug from the receptacle when chang- ing blades.
- Page 7 cuttinG CAUTION! In order to prevent blade dislodging, damage or excessive wear on the plunger, please make sure to have surface attached to the work piece while sawing. 1. Rectilinear cutting When cutting on a straight line, first draw a marking gauge line and advance the saw along that line.
-
Page 8: Connecting With Cleaner
NOTE: Angular cutting cannot be done when adopting chip cover or dust collector. connectinG with cleaner By connecting with cleaner (sold separately) through dust collector and adopter (sold separately), most of dust can be collected. (1) Remove the allen wrench from the base. (2) Move the base fully forward. - Page 9 Keep the brushes clean and ensure that brushes move freely within the brush holders. 7. Replacing power cord In case power cord of the tool is damaged, contact ZENIT authorized service center to replace it. CAUTION When using the drill follow these rules: •...
- Page 10 Demix LLC Head office: 14, Shevchenko str., 3rd floor Dnepropetrovsk, Ukraine, 49044 tel./fax: +38 056 375-43-16 http://www.en.zenit-profi.com...