Dell Dimension 8200 Solution Manual page 82

HINT: Two sets of rails
are attached to the inside
of the computer cover.
Use the two longer rails
on 5.25-inch drives.
Use the shorter rails for
3.5-inch drives. Rails for
a second hard drive are
attached inside the hard-
drive bay.
82 Ad d i n g Par ts
Remove the two green plastic rails from the inside of the hard-drive
6
bay.
These rails are not attached to the inside of the hard-drive bay with
screws. To remove the rails, gently pull the rails up and out of the bay.
Attach the rails to the hard drive using the two screws attached to the
7
rails.
Ensure that the rail tabs are positioned at the back of the hard drive.
NOTICE: Do not install any drive into the lower hard-drive bay until after you
have removed the green drive rails from the inside of the hard-drive cage.
Remove the first hard drive from the upper bay and install it in the
8
lower bay:
Disconnect the power cable and the data cable from the back of
a
the first hard drive.
Press in the two green rail tabs and pull the first hard drive out of
b
the upper bay.
Gently slide the first hard drive into the lower bay until you hear a
c
click.
Reconnect the power cable and the data cable to the back of the
d
first hard drive.
Gently slide the new hard drive into the upper bay until you hear a
9
click.