Battery; Replacing The Battery - Dell Dimension 3100C Owner's Manual

3 If you are replacing an existing drive:
Press the two snaps on the top of the drive-panel insert and rotate the insert toward the
a
front of the computer.
Remove the three shoulder screws from the existing drive.
b
Insert the three shoulder screws into the sides of the new drive and tighten them.
c
4 Connect the power and DVD drive cables to the drive.
5 Align the shoulder screws with the screw guides, and slide the drive into the bay until it clicks
into place.
6 Check all cable connections, and fold cables out of the way to provide airflow for the fan and
cooling vents.
7 Replace the computer cover (see "Replacing the Computer Cover" on page 84).

Battery

Replacing the Battery

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer's electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
A coin-cell battery maintains computer configuration, date, and time information. The battery
can last several years.
If you have to repeatedly reset time and date information after turning on the computer, replace
the battery.
CAUTION:
A new battery can explode if it is incorrectly installed. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions.
To replace the battery:
1 Record all the screens in system setup (see page 91) so that you can restore the correct
settings in step 8.
2 Follow the procedures in "Before You Begin" on page 53.
3 Locate the battery socket (see page 61).
NOTICE:
If you pry the battery out of its socket with a blunt object, be careful not to touch the system
board with the object. Ensure that the object is inserted between the battery and the socket before you
attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or
by breaking circuit traces on the system board.
Removing and Installing Parts
83