Dell Dimension 1100 Owner's Manual page 60

not fully seated card
fully seated card
4 Secure the card bracket with the screw you removed in step 2.
5 Connect any cables that should be attached to the card.
See the documentation for the card for information about the card's cable connections.
NOTICE:
Do not route card cables over or behind the cards. Cables routed over the cards can cause damage to
the equipment.
6 If you installed a sound card:
Enter system setup (see page 82), select Audio Controller, and then change the setting to Off.
a
Connect external audio devices to the sound card's connectors. Do not connect external audio
b
devices to the microphone, speaker/headphone, or line-in connectors on the back panel.
7 If you installed an add-in network adapter and want to disable the integrated network adapter:
Enter system setup (see page 82), select Network Controller, and then change the setting to Off.
a
Connect the network cable to the add-in network adapter's connectors. Do not connect the
b
network cable to the integrated connector on the back panel.
8 Install any drivers required for the card as described in the card documentation.
Removing a PCI Card
1 Follow the procedures in "Before You Begin" on page 47.
2 If necessary, disconnect any cables connected to the card.
60
Removing and Installing Parts
bracket
within slot
bracket caught
outside of slot