Advertisement
Stage 3: Attaching Wheels
For this stage you will require:
(1) Frame Assembly (from previous stage)
(2) Cotter Pins
FIGURE 9
Place wheels on each spindle with
the grease nipple facing inwards.
Add an M21 washer and install cotter
pin through the hole in the end of the
axle for both wheels (see fig 10).
Stage 4: Attaching Hitch
For this stage you will require:
(1) Completed Assembly (from previous stage)
(1) Tipper Latch
(4) M12 Washer
(2) M10 Washers
FIGURE 12
Place the hitch bar so that the
beveled edge faces down and
towards the back of the unit. Secure
in place using an M12 x 90 mm hex
head bolt 2 washers and an M12
locknut.
NOTE: Washers are placed on the
outside of both sides of the channel.
(2) Tire and Rim
(2) M21 Washers
FIGURE 10
Ensure both tabs of the cotter pins are separated after placement.
Finally, grease wheel bearings with a grease gun, using grease nipples on
the inside of each wheel.
(1) Hitch Bar)
(1) M12 x 90 mm Hex Head Bolt
(3) M12 Lock Nut
(2) M10 Lock Nuts
FIGURE 13
Secure the Ball coupler in place using
two M12 x 80 mm hex head bolts and
two M12 locknuts and two
M12 Washers.
FIGURE 11
(1) Ball Coupler
(2) M12 x 80 mm Hex Head Bolts
(2) M10 x 75 mm Hex Head Bolts
FIGURE 14
Using two M10 x 75 mm hex head
bolts, two M10 lock nuts and two
M10 washers, secure the
tipper latch in place.
Advertisement
