Attaching The Turbocharger To The Bracket - ABB TPX Series Assembly Instructions Manual

Assembly Instructions / TPX44-H
4 Installing the turbocharger / 4.3 Attaching the turbocharger to the
bracket
4.3

Attaching the turbocharger to the bracket

Fig. 8: Placing the turbocharger on the bracket
Product Through hole in
bearing casing [mm]
TPX44-H
Table 7: Tightening torque for turbocharger fixing screws
1. Make sure that the covers of the oil and water connections are removed.
2. Make sure that the gaskets are not damaged and are positioned correctly in the slots.
3. Install the swivel lifting eye (S) and attach the lifting gear to it.
4. Align the turbocharger over the threaded rods of the bracket.
5. Place the turbocharger on the bracket.
6. Lightly oil the hexagon nuts.
7. Fit the hexagon nuts. Observe the tightening torque.
8. Connect cable to speed sensor (86505).
Remove the lifting gear.
u
Connect all gas and air lines, as well as the oil supply line, according to the instructions of
u
the enginebuilder.
Fit the water pipes according to the instructions of the enginebuilder.
u
© Copyright 2019 ABB. All rights reserved.
Fixing screws [mm]
Ø 14
HZTL455311P0037_EN
Tightening torque [Nm]
(assumed friction coeffi-
M12
Rev.A
cient µ = 0.12)
100
November 2019