Assembly Instructions / A200-H
4 Installing the turbocharger / 4.3 Placing and aligning the turbochar-
ger on the bracket
4.3
Placing and aligning the turbocharger on the
bracket
Step A – Preparing the fixing screws
Fig. 7: Placing and aligning the turbocharger
1. Place the turbocharger roughly over the bracket, but do not set it down yet.
2. Screw the clamping nut (42201) flush onto the threaded rod (03).
3. Insert the threaded rod through the washer (02) of the clamping nut.
4. Feed the threaded rod through the bearing casing.
Step B – Preparing the positioning
Fig. 8: Screwing on the centering bush
Screw the centering bush (04) flush onto the threaded rod from below.
u
Clean the surface of the bracket, the bearing casing, the centering bush and the centering
u
holes in the bracket.
© Copyright 2021 ABB. All rights reserved.
HZTL455311P0042_EN
Rev.A
September 2021