Operation - U.S.SAWS CORE EZ Operating Manual

WARNING: Always insure that the switch is in the "OFF" position
before plugging the unit into electrical power.
CAUTION: Never leave the drill running unattended. Turn power off
when not in use.
6.1 Mark center of core.
6.2 Drill anchor hole with 3/8" masonry bit a minimum
of 5" deep, unless using toggle anchors.
Set anchor pin.
6.3
O P E R AT I O N
6.4
6.5
6.6
Waterworks
Division
Remove nuts from anchor bolt.
Mount guide post.
Adjust anchor point.
CAUTION: Once the guide post is tight, push and
pull on it several times by hand to stretch and
seat the anchor into its tightest position, then,
re-tighten the guide post. Repeat this complete
procedure three times to ensure that the guide
post is securely centered.
P: 866 987-7297 F: 813-621-7125
Visit us at www.ussaws.com
sales@ussaws.com
7