Aan/Uit-Knop; Removing The Power Button - Dell Precision 7750 Service Manual

Steps
1. Align and place the SD care reader with its slot on the palmrest.
2. Replace the (M2.5x2.5) screw to secure the SD card reader to the palmrest.
3. Connect the LED board cable to the SD card reader on the bottom side of the computer.
4. Connect the SD card reader cable to the connector on the system board.
Next steps
1. Install the inner frame.
2. Install the WLAN card.
3. Install the WWAN card.
4. Install the primary M.2 SSD.
5. Install the inner frame.
6. Install the battery.
7. Install the base cover.
8. Install the SD card.
9. Follow the procedure in

Aan/uit-knop

Removing the power button

Prerequisites
1. Follow the procedure in
2. Remove the SD card.
3. Remove the base cover.
4. Remove the battery.
5. Remove the heat-sink assembly.
6. Remove the power button
About this task
The figure indicates the location of the power button and provides a visual representation of the removal procedure.
after working inside your computer.
before working inside your
board.
computer.
Demonteren en hermonteren 57