AEG SCB818E6TS User Manual page 19

Problem
There is too much con-
densed water on the rear
wall of the refrigerator.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Door was opened too fre-
quently.
Door was not closed com-
pletely.
Stored food was not wrap-
ped.
Food products prevent the
water from flowing into the
water collector.
The water outlet is clogged.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The "Frostmatic function" or
"Coolmatic function" is
switched on.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The door has been opened
often.
The Frostmatic function is
switched on.
The Coolmatic function is
switched on.
ENGLISH
Solution
Open the door only when
necessary.
Make sure the door is closed
completely.
Wrap food in suitable pack-
aging before storing it in the
appliance.
Make sure that food prod-
ucts do not touch the rear
plate.
Clean the water outlet.
Attach the melting water
outlet to the evaporative
tray.
Switch off "Frostmatic func-
tion" or "Coolmatic func-
tion" manually, or wait until
the function deactivates au-
tomatically to set the tem-
perature. Refer to "Frostmat-
ic function" or "Coolmatic
function" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Refer to "Frostmatic func-
tion" section.
Refer to "Coolmatic func-
tion" section.
19