TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from
the instructions below on how to quickly and easily set up your new tree.
1. Before you start to assemble your tree, choose an appropriate location near a wall outlet.
2.Assemble the tree stand and place on a level surface. (See Fig. A)
Fig. A - Tree Stand Assembly
Fig. B - Tree and Light Assembly
Insert Red Label Plug
Into Red Label Socket
Of The Main Controller
Insert Blue Label
Plug Into Blue Label
Socket Of The
Main Controller
Insert Yellow Label Plug
Into Yellow Label Socket
Of The Main Controller
Section 1
Input:120VAC, 60Hz, 0.5A
Insert
Green Label
Plug Into Wall
Outlet
3. Each tree section is numbered with a tag. Please identify all sections before assembling.
4. Assemble the tree from the bottom to the top. Start with the bottom section and remove protective
cap before inserting into the assembled stand. Make sure the pole is firmly inserted and secured into
the stand.
5. Continue by inserting the upper tree section(s) to the lower section(s) until inserting the tree top.
6. Allow branches to fall into place or gently pull up and out.When adjusting branches, be sure that all
wires are free of branch hinges.
7. Just plug the adaptor (connecting with the tree power cord) into the wall outlet (See Fig. B), your
entire tree should now be lit. If some bulbs do not light or flickers, search for any loose plugs and/or
broken, loose or missing bulbs. Replace bulbs promptly in order to maintain the performance and life
expectancy of your pre-lit tree.
8. Connect the red label extension cord of the digital light from the tree top section to the red label socket
on the main controller box and then twisting the lock-nut in clockwise by hand tighten.
9. Connect the blue label extension cord of the digital light from the tree middle section to the blue label
socket on the main controller box and then twisting the lock-nut in clockwise by hand tighten.
10. Connect the yellow label extension cord of the digital light from the tree lower section to the yellow
label socket on the main controller box and then twisting the lock-nut in clockwise by hand tighten.
NOTE: Ensure the three extension cords are connected onto the correct sockets on the main controller
before plug the main controller power cord from the wall outlet to power on the digital lights.
MODEL #: TG76P3914L00,DLCW2IRGB601(LI400LC-CC-B2)
Polygroup
Click
Section 3
Section 2
! Carefully follow
Pull apart the legs of the stand so that they
are snapped into an x-shape, place the tree
stand on a level surface.
To close the stand, press the metal button
and fold the legs together.
*Electrical Rating For The Tree
(For Indoor Use Only)
Do Not Tamper With
Internal Parts
Open the
protective
cover
Do Not Tamper With
Internal Parts
Open the
protective
cover
Input:120VAC, 60Hz, 0.16A
Output: 29V DC 0.28A
Adaptor
To Be Plugged
Into Wall
Outlet