Summary of Contents for Otto CONTOUR 3 DRAWER PEDESTAL JBCONT3DPD
Page 1
ASSEMBLY INSTRUCTIONS CONTOUR 3 DRAWER PEDESTAL JBCONT3DPD This design and instruction booklet is subject to copyright. 1 Carton www.officeworks.com.au For spare parts or hardware call (03) 9310 3011 or email hardware@kyvas.com.au...
Page 2
Estimated Assemble Time: 20min Customer Service People Required General Advice Contact Details One Person Is Required To Spare Parts & Hardware Assemble On A Clear Flat Safely Assemble The Item (03) 9310 3011 Surface Tools Required CAUTION Do not use tools other than those required, as this can damage your new item.
Hardware List Hardware Pack located in Carton - JBCONT3DPD ( 4 x 18 mm) ( 3.5 x 14 mm) Spanner X 6 pcs X 1 pc X 16 pcs Plastic Cap X 5 pcs Other hardware located in Carton - JBCONT3DPD X 2pcs X 2pcs X 1pc...
Care Advice Care Insturections - UV Board Pedestal Keep away and protect from direct sunlight and heat. Do not place sharp materials(knife, fork, etc) directly onto your furniture as sharp material may scrape and damage the finish. Clean up spills quickly. Water left over a prolonged period of time may cause damage.
Page 9
Warranty 3 years Product Warranty – valid for Australian customers only Officeworks Ltd warrants that this product will be free from defects and work as intended for 3 years from the date of purchase by the original customer. If the product has any defects or does not work as intended during the Warranty Period, Officeworks will, at its election and at its expense, repair or replace the product.
Need help?
Do you have a question about the CONTOUR 3 DRAWER PEDESTAL JBCONT3DPD and is the answer not in the manual?
Questions and answers