Table of Contents
Advertisement
7. Test the transmitter by setting dip switch #4 to the "Test" position, as shown below.
You should see a flashing LED indicating that the sensor unit is transmitting.
8. Install the receiver into the console base and apply power as shown below.
Be sure to connect the receiver's cable plug into the jack marked "Junction
Box" on the underside of the station console.
STANDARD SETUP
To
Power
Adapter
When you apply power to the console, the console should beep three times
within 20 seconds to indicate that the console and receiver are working
properly (or 4 times within 30 seconds, with the optional WeatherLink).
Installation
TRANSMITTER TEST
Dip Switches
UNIT ID
TEST
ON
S1
1 2 3 4
RUN
Weather Station
Console
Antenna
SensorLink
Receiver
Mounting Base
Indicator
LED
SensorLink
Transmitter
WEATHERLINK SETUP
To
Power
Adapter
Weather Station
Console
SensorLink
Receiver
WeatherLink
Mounting Base
Page 7
Advertisement
Table of Contents
