Table of Contents
Advertisement
T
M
OOLS AND
ATERIALS
In addition to the components listed above, you may need some of the follow-
ing tools and materials. Please be sure you have everything you need before
beginning the installation.
Phillips Screwdriver
Pencil or Other Pointed Object
C
ONFIGURING
Both the transmitter and receiver have a set of dip switches which enable you
to change the ID code and warnings settings.
TRANSMITTER DIP SWITCHES
Setting the ID Code
The wireless weather station may be set to use any of eight selectable ID codes
(the default is ID Code #1). The transmitter and receiver will only communi-
cate with each other if they are both set to the same ID code. Use the default
setting unless you have another Davis wireless weather station operating
nearby which you want to work separately from the new system. The dip
switch settings for the eight possible codes are shown below.
ID C
#1
To change to another ID, toggle dip switches 1, 2, and/or 3 on both the trans-
mitter and receiver to the desired code. Remember that the transmitter and
receiver must use the same ID code in order to communicate. If, later, you ever
want to change ID codes, remember that you will need to remove and reapply
power to the console before the changes take effect.
Note: Dip switch #4 is used for testing and warnings, not for ID codes.
Page 2
N
EEDED
T
/R
RANSMITTER
ON
S1
1 2 3 4
D
S
ODE
IP
WITCH
off
(default)
#2
off
#3
off
#4
off
#5
ON
#6
ON
#7
ON
#8
ON
P
ECEIVER
AIR
UNIT ID
ON
1 2 3 4
1 D
S
2 D
IP
WITCH
off
off
ON
ON
off
off
ON
ON
RECEIVER DIP SWITCHES
S
3
IP
WITCH
off
ON
off
ON
off
ON
off
ON
SensorLink™
Advertisement
Table of Contents
