Table of Contents
Advertisement
st
12.3 1
boom dual effect kit
This kit is an option ONLY for RH machines, while it is provided as standard in LH
machines.
CAUTION
The 1
st
boom dual effect kit makes it possible to work in a vertical position without the boom falling into rest position.
This device improves the sensitivity of the tool.
12.3.1 Assembly instructions
►
Identify the control valve element (
then fully unscrew the lock nut (1) of the cable pulling device and the four screws (2) that fasten the slider upper
cover (3).
►
Then, tighten the cable adjuster until the cover (3) is completely raised.
►
Disassemble the lower cover (4) of the slider using the corresponding screws (5).
Rev. 1.0
) that controls the 1
boom (easily recognisable since it has only one hose),
A
st
2
A
4
T380D-T430D
OPTIONAL UNITS
1
3
5
12.9
135
Advertisement
Table of Contents
