Drain the water. ~ Page 42
3.
Pull the emergency release
4.
downwards with a tool and release.
The door can then be opened.
Information on the display panel
Display
Õ
•©£
r
E lights up
The symbol Û
flashes
E:36
alternating with
-10
Cause/Remedy
Flashes fast + signal: The door was opened and the water level is too high.
■
Close the door, continue the programme with A (Start/Reload/Pause)
button or select Drain.
Flashes slowly: The door lock temperature is too high to open the door. Wait
■
approx. 30 seconds until the door lock temperature cools down.
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the •©£ disappears on the display panel, then the door can
be opened.
Flashes (no water supply): Water tap turned on? Filter in the water supply is
■
blocked? ~ "Filter in the water supply is blocked" on page 43
Is the supply hose kinked or trapped?
Lights up (low water pressure): For information only. This will not affect the
■
programme progress. The programme duration is extended.
The childproof lock is activated – deactivate it.
Run the Cotton 90°C programme to clean and care for the drum and the outer tub.
Notes
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
■
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
Switching the drum care information signal on/off. ~ Page 39
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
■
outlet hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
■
and water drain hose are not kinked or trapped.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 42
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 43
The water drain hose is connected too high. Install the water outlet hose at a
■
maximum height of 1 meter.
~ Page 16
Faults and what to do about them
en
45