Table of Contents
Advertisement
Powering on/off
Connecting the power cord
Make sure that the supplied power cord is securely fixed to the <AC IN> terminal of the projector body to
prevent it from being removed easily.
For details of power cord handling, refer to "Read this first!" (x page 4).
Attaching
1)
Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the connector completely in the correct direction.
Removing
1)
Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2)
Remove the power cord connector from the <AC IN> terminal.
Power indicator
The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Confirm the status of the power
indicator <ON(G)/STANDBY(R)> before operating the projector.
Power indicator <ON(G)/STANDBY(R)>
Indicator status
Off
Lit
Red
Blinking*
1
Blinking*
2
38 - ENGLISH
Chapter 3 Basic Operations - Powering on/off
VOL-
VOL+
AV MUTE
The power plug is not connected to the outlet.
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [ECO].
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NETWORK].
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NORMAL].
x
Status
Advertisement
Table of Contents
