Advertisement
To clean or replace the blade shafts
1. Remove the nuts and screws from the blade shafts.
2. Pull the blade shafts from the hub.
3. Replace damaged blade shafts.
4. Clean the contact surfaces on the blade shafts and
the hub.
5. Lubricate the contact surfaces and install the blade
shafts.
To lubricate the blade shafts
•
Push grease through the grease nipples until grease
comes out around the blade shafts.
1124 - 001 - 06.04.2020
To clean or replace the bearing for the
pressure plate
1. Remove the screw and washer.
2. Remove the blade assembly. Use a puller if the
blade assembly is not easy to remove.
3. Remove the pressure plate (A), the ball bearing (B),
the bushing (C) and bearing plate (D).
B
4. Clean the surfaces of all parts and lubricate
carefully.
5. Lubricate the ball bearing with grease. Refer to
Technical data on page 16 for correct type of
grease.
6. Assemble in the opposite sequence.
D
C
A
11
Advertisement
