Datamax W-6208 Quick Start Manual page 2

Ì
Loading Media
Í
Printer
Controls
With the Printer On, and loaded with media (at least 6 inches wide):
Î
Ø Verify the printer is in the 'Ready Mode'
Ø Press the
Printing a Test
Ø Using the button scroll to 'Print Config Label'. Press the
Label
button again, after a brief hesitation the printer will print one
Configuration Label.
Ø Rotate the
Printhead Latch
and raise the
printhead
Ø Slide the Roll
Media onto the
Media Hub
Ø
Route the
Media as
è
shown
ŒPause: Toggles the pause condition.
ŒArrow Up:
•Feed: The FEED button feeds a
label, and clears any faults
•Arrow Down:Moves to the previous item in
that have been corrected.
ŽCancel: Cancels a job and pauses the
printer.
ŽEnter:
•Menu: Toggles between the ready
and menu mode.
•ESC:
•Test:
Enables the quick test mode,
see the Operators Manual
for additional information.
è
button.
Ø Route the media through one of the external slots in the
Ø With the Roller Lever in its down slide the Fan Fold
Ø Tighten the Thumbscrew on the bottom of the Fan Fold
Internal Media Loading
Moves to the next item in the
menu tree, (increase values).
the menu mode, (decrease
values).
Selects a displayed item or
value.
Moves to the previous menu
level.
'
Additional
Information
printer and over the top of the Media Supply Hub.
Media Guide onto the Media Supply Hub until it rests
against the inside edge of the slot in the Fan Fold Guide
and raise the Roller Lever to its up position.
Guide.
Refer to the Operator's Manual for the Printhead Cam Adjustment when
using narrow media.
Be sure to follow and perform the suggested Cleaning Schedule listed in
the Operator's Manual.
Contacting Datamax...
Corporate Headquarters
Technical Support (407) 523-5540
For the latest products, news, and support visit our web page at
www.datamaxcorp.com
External Media
Loading
ŒReady:
On indicates ready,
blinking indicates menu mode.
•Stop: On indicates paused state.
ŽError: On indicates a fault. To clear a fault
press the feed button.
(407) 578-8007