Datamax ST-3210 Programmer's Manual page 10

Command
No Status
Parking Ticket Command
Partial ASCII Status
Pcx File Being Sent
Command
Print Downloadable Font
Command
Print Downloadable Logo
Command
Print Intensity
Print Resident Logo
Command
Print Ticket Count
Command
Prom Type And Ticket
Count Status Request
Purge Printer Of
Remaining Tickets
Command
Scale Down Command
Shade Pattern #
Shade Pattern In
Background
Shade Pattern In
Foreground
Starting Point Command
Status Request
Test Button Disabled
Command
Test Button Enabled
Command
6
Format
<S5> or <s5> Disables the transmission of all status information, except for x-on/off information.
<PT> or <pt> Reverses the ticket to the print position after the last ticket in a group has been printed.
<S8> or <s8> All status information, except for a valid xon/xoff, will have 30h added to them to
convert them to an ASCII value.
<pcx> Notifies the printer that a PCX image file is being sent to the printer.
<SF#> Use this font command to specify the desired font.
<LD#> The Printer prints one of its customer-downloaded logos on the ticket.
<lve#> Adjusts the print intensity at a given speed setting. The # value may range from –5 to +5.
<LO#> Causes the Printer to print any one of its factory pre-loaded logos on the ticket.
<PC> Prints the total amount of tickets printed on that printer.
<S2> The printer will respond with a seven-digit ticket count followed by the software level of
the printer.
<PP> In this mode, when the printer runs out of tickets it will purge all remaining ticket
information. It will also reset the ticket count to zero.
<SD#> Fonts will be divided by the # indicated in the scale down command.
<PA#> The number sent is the pattern that you want to shade with. Pattern #
0 - white
1 - very light course dot pattern
2 - light course dot pattern
3 - light - medium course dot pattern
4 - medium course dot pattern
5 - dark - medium course dot pattern
6 - dark course dot pattern
7 - open
8 - open
9 - black
10 - white
11 - very light fine dot pattern
12 - light fine dot pattern
<PAB> Sets the shading to occur in the background.
<PAF> Sets the shading to occur in the foreground.
<SP#,#> Assigns the starting location of the logo.
<S1> Instructs the printer to respond with a one byte status message.
<td> Disables the test button on the printer.
<te> Enables the test button on the printer.
Description
13 - light medium fine dot pattern
14 - medium fine dot pattern
15 - dark - medium fine dot pattern
16 - dark fine dot pattern
17 - open
18 - open
19 - black
20 - vertical lines
21 - horizontal lines
22 - forward diagonal lines
23 - backward diagonal lines
24 - square grid
25 - diagonal grid
DTPL Programmer's Manual