Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Drija Milan 90
Summary of Contents for Drija Milan 90
-
Page 2: Table Of Contents
User Manual BUILT-IN GAS STOVE | MILÁN 90 1. INTRODUCTION ......................2 2. SECURITY WARNING ....................3 3. HOW TO USE YOUR STOVE ..................4 4. HOW TO TAKE CARE OF YOUR GAS STOVE .............. 5 5. INSTALLATION ....................... 8 6. -
Page 3: Introduction
User Manual BUILT-IN GAS STOVE | MILÁN 90 1. INTRODUCTION Thank you for choosing our gas cook top. To use this artifact correctly and prevent any potential risk, read these instructions before using Keep these instructions in a place where you can find easily. If you are not sure of any of the information contained in these instructions, please contact our customer service center. -
Page 4: Security Warning
User Manual BUILT-IN GAS STOVE | MILÁN 90 2. SECURITY WARNING 1. Auxiliary burner 2. Semi-rapid burner 3. Rapid burner 4. Triple ring wok burner 5. Ignitor for Gas Burners 6. Safety Device:- Activates if the flame accidentally goes out (spills, drafts, etc.), interrupting the delivery of gas to the burner. -
Page 5: How To Use Your Stove
User Manual BUILT-IN GAS STOVE | MILÁN 90 MODELS MILAN 90 Cooking Zone Voltage 110/240V 50/60Hz Total Power 11.6kW Front Side control operation Product Size D×W×H (mm) 870 x 500 x 100 Cut Out Dimensions D x W (mm) 840 x 480 3. -
Page 6: How To Take Care Of Your Gas Stove
User Manual BUILT-IN GAS STOVE | MILÁN 90 On those models equipped with a safety device The knob should be pressed for approximately 6 seconds until the flame ignites and heats up. On those models equipped with a lighter The electric power button, identified by the symbol, must be pressed first, then the corresponding knob is pushed and turned counterclockwise to the "High"... - Page 7 User Manual BUILT-IN GAS STOVE | MILÁN 90 While the cooking surface is warm, clean it with a suitable cleaning product and paper towels, then wipe with a damp cloth and a dry surface. Like aluminum foil, plastic items, objects made of synthetic material, sugar or foods with a high sugar content that have melted on the surface, it must be removed immediately.
- Page 8 User Manual BUILT-IN GAS STOVE | MILÁN 90 Burner Ø Cookware diameter (cm) Auxiliary burner 10~14 Semi-rapid burner 16~20 Rapid burner 22~24 Triple ring wok burner 24~26 To identify the type of burner, refer to the designs in the section entitled "Burner and nozzle specifications".
-
Page 9: Installation
User Manual BUILT-IN GAS STOVE | MILÁN 90 The kitchen battery is not stable, check to make sure that: The bottom of the kitchen utensils is perfectly flat. The kitchen battery is centered correctly on the burner. The support grilles have not been inverted. After verifying all this, the gas plate still does not work properly, call the Customer Service Center and inform them about: - Indicate what problem it presents. - Page 10 User Manual BUILT-IN GAS STOVE | MILÁN 90 b) Air must be allowed for adequate combustion. The air flow for combustion purposes must not be less than 2 m³ / h per kW of installed capacity. The air supply will be effected by the inflow from the outside through a duct, its internal cross section is at least 100 cm²...
- Page 11 User Manual BUILT-IN GAS STOVE | MILÁN 90 c) The cabinets should be placed near the hood at a height of at least 420 mm (Fig. d) The plate must be installed directly under a cabinet, the latter must be at least 700 mm from the worktop, as shown in Fig.
- Page 12 User Manual BUILT-IN GAS STOVE | MILÁN 90 Hook position for Hook position for Hook position for H=20mm top H=30mm top H=40mm top f) In the event that the gas plate is not installed in a built-in oven, a wooden panel must be inserted for insulation.
- Page 13 User Manual BUILT-IN GAS STOVE | MILÁN 90 Gas connection for gas hob The gas plate must be connected to the gas supply by a registered installer. During installation, it is essential to install an approved gas tap to isolate the supply of the plate for the convenience of any subsequent extraction or service.
- Page 14 User Manual BUILT-IN GAS STOVE | MILÁN 90 In the case of installation on a built-in electric oven, the electrical connections for the plate and the oven must be independent, not only for a safe purpose, but also suitable for future disposal.
-
Page 15: Specifications Tables
User Manual BUILT-IN GAS STOVE | MILÁN 90 6. SPECIFICATIONS TABLES Burner and nozzle specifications Adapting the Gas hob for Different Types of Gas Burner Thermal Nozzle Thermal power Nozzle 1/100 power (kW) 1/100 (mm) (kW) (mm) Auxiliary (Small) (A) Semi rapid 1.80 (Medium) - Page 16 User Manual BUILT-IN GAS STOVE | MILÁN 90 label containing that information on the appliance. How to convert a gas source Adjustment of the reduced valve flow Burners Flame Converting the Converting the hob from LPG hob from natural gas to natural gas Gas to LPG Full flame...
- Page 17 User Manual BUILT-IN GAS STOVE | MILÁN 90 -Burner ON, large flame -Burner ON, small flame（saving mode） -Burner OFF Fig.8 See fig.8 for various operating options (flame size selection); the burner should be set at a large flame during the initial phase of cooking, it make food boil quickly. Then should turn knob to the saving flame position to maintain the cooking.
- Page 18 User Manual BUILT-IN GAS STOVE | MILÁN 90 Natural — 3440 1548 Triple-ring wok Butane — 3440 1548 NOTICE: A. Before installation, make sure that the local distribution condition (nature of the gas pressure) and the setting of the appliance are compatible ”. B.
Need help?
Do you have a question about the Milan 90 and is the answer not in the manual?
Questions and answers