Operation - Malmbergs HP18190MHR Instruction Manual

OPERATION

1. Stand the machine up, placed on a flat ground.
2. Check the water inlet filter to make sure it is free of blockage.
3. Use detergent to make better wash.
4. Connect the nozzle onto the spray lance and the lance onto the gun handle.
5. Connect the gun with the high pressure hose which is on the winding roll.
6. Push the high pressure hose out of the winding roll.
7. Connect the hose onto the water output exit.
8. Connect the water supply hose to the water entry of the machine.
9. Connect the other end of the supply hose to water source.
10. Press the gun trigger and turn on the water tap to expel the air inside the machine.
11. Plug in and turn on the machine.
12. Turn the nozzle until the water stream is in a shape you want. See pic 1 and pic 2.
13. After use, turn off the water tap, and then switch, finally plug out.
1
ASSEMBLY
1
Recommended process
Hose to gun
attaching to unit
set low water pressure, open the tap and trigger the gun to remove the air in the unit
connecting to power
work
Note: water inlet hose connect to tap through quick connector.
Water outlet
2
hose to water outlet tube
water inlet hose to tap
turn on the appliance, change to high pressure setting
2
5
Switch
3
Water inlet connector
Water inlet
water inlet hose to quick connector
lance to gun
Connector to tap
4
pull the lance head to
start to
25