Operation - Malmbergs HP18160SL Instruction Manual

OPERATION

1. Stand the machine up, placed on a flat ground.
2. Check the water inlet filter to make sure it is free of blockage.
3. Connect the nozzle onto the spray lance and the lance onto the gun handle.
4. Connect the gun with the high pressure hose.
5. Connect the hose onto the water output exit.
6. Connect the water supply hose to the water entry of the machine.
7. Connect the other end of the supply hose to water source.
8. Press the gun trigger and turn on the water tap to expel the air inside the machine.
9. Plug in and turn on the machine.
10. Turn the nozzle until the water stream is in a shape you want. See pic 1 and pic 2.
11. After use, turn off the water tap, and then switch, finally plug out.
1
ASSEMBLY
Water inlet connector
Recommended process
Hose to gun
attaching to unit
set low water pressure, open the tap and trigger the gun to remove the air in the unit
connecting to power
work
Note: water inlet hose connect to tap through quick connector.
Connector to tap
4
Water inlet
3
hose to water outlet tube
water inlet hose to tap
turn on the appliance, change to high pressure setting
2
5
Switch
2
Water outlet
water inlet hose to quick connector
lance to gun
1
pull the lance head to
start to
23