Intellisystem IT350W Quick Installation Manual

Network camera with pan/tilt/zoom
Hide thumbs Also See for IT350W:

Advertisement

IT350W Network Camera
with Pan/Tilt/Zoom
Quick Installation Guide
This guide describes the basic functions of
IT350W Network Camera.
All detailed information is described in the
user's manual.
Intellisystem Technologies S.r.l. - http://www.intellisystem.it

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IT350W and is the answer not in the manual?

Questions and answers

Summary of Contents for Intellisystem IT350W

  • Page 1 IT350W Network Camera with Pan/Tilt/Zoom Quick Installation Guide This guide describes the basic functions of IT350W Network Camera. All detailed information is described in the user's manual. Intellisystem Technologies S.r.l. - http://www.intellisystem.it...
  • Page 2 IT350W Quick Start Guide Warning Before Install Power o the Network Camera Keep the Network Camera as soon as it is found away from the water. If the smoking or smelt unusual. Network Camera is wet, power o immediately. Contact your distributor when such Contact your distributor when such cases happen.
  • Page 3 IT350W Quick Start Guide Do not place the Network Do not touch the Network Camera on unsteady Camera when it's lightening. surfaces. Do not disassemble the Do not drop the Network Network Camera. Camera. E THE R NE T E XT.I/O 1.5A...
  • Page 4: Check Package Contents

    IT350W Quick Start Guide Check package contents Network Camera Power adapter Camera stand A/V cable Software CD Remote controller Home Auto-Patrol Auto-Pan Center Stop Intellisystem Technologies S.r.l. - http://www.intellisystem.it...
  • Page 5: Physical Description

    IT350W Quick Start Guide Physical description Front panel Antennas Lens Microphone Power/MIC Activity Status LEDs Rear panel Antennas Network Camera Model IT350W SN/MAC: 0002D001XXXX Made in Taiwan E THE R NE T E XT.I/O 1.5A A/V out Note the serial number on the label of the unit.
  • Page 6 IT350W Quick Start Guide Install the Network Camera in Ethernet network 1.If external devices such as sensors and alarms are available, make connection to the I/O terminal block. Refer to the user's manual for the I/O voltages. 2.Use an Ethernet cable to make connection from the Ethernet port to the hub.
  • Page 7: Assign Ip Address

    IT350W Quick Start Guide Assign IP address 1.Run the "Network Camera Wizard" under "Utility" directory on the software CD. 2.The program will search Video Servers or Network Cameras on the same LAN. 3.After searching, the main installer window will pop up.
  • Page 8 IT350W Quick Start Guide The Internet Explorer Connects to the Network Camera For further setup, please check the user's manual on the software CD. Intellisystem Technologies S.r.l. - http://www.intellisystem.it...

Table of Contents