Electrolux FI23/11V User Manual page 12

12 www.electrolux.com
Problem
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
7.2 Replacing the lamp
Disconnect the plug from the mains
socket.
1. Remove the screw from the lamp
cover.
2. Remove the lamp cover (refer to the
illustration).
Possible cause
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
3. Replace the used lamp with a new
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains
7. Open the door.
Make sure that the light comes on.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Solution
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
lamp of the same power and
specifically designed for household
appliances (the maximum power is
shown on the lamp cover).
socket.
to "Installation".
door gaskets. Contact the Authorised
Service Centre.