Termination; Diagnostics - Bosch Rexroth IndraControl VCP 11.2 Project Planning Manual

The small operator terminal vcp 11 is a machine operator terminal which can initiate functions in the machine as defined in the application

Table of Contents

R911311481 / 03 | Rexroth IndraControl VCP 11.2

Interfaces

7.3.1.3 Termination

Electric Drives and Controls | Bosch Rexroth AG

19245 Part 3).

Baud Rate

187.5 kBit/s

500 kBit/s

1500 kBit/s

3000 to 12000 kBit/s

Fig. 7-19: Baud rate PROFIBUS

Terminate the PROFIBUS at both ends by terminating resistors. If you

are using special PROFIBUS connectors, these resistors are usually

integrated into the connector and can be connected.

A diagnostics LED is located on the rear of the small operator terminal.

The LED shows the states of the bus system.

The diagnostics LED on the small operator terminal has the following

function:

Color

State

Function

Green

Communication Active

Fig. 7-20: Function of the PROFIBUS-DP diagnostics LED

Cable Length

1000 m (3280.839 feet)

400 m (1312.335 feet)

200 m (656.167 feet)

100 m (328.083 feet)

7-11

Table of Contents

Table of Contents