Assembly - Craftsman 580.752770 Operator's Manual

Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle
• Billboard
• High Pressure Hose
• Spray Gun
• Spray Wand with Quick Connect
• Oil Pouch
• PerfectMix™ Siphoning Tube
• Bottle Bracket Wireform
• Gun Holder Wireform
• Parts Bag (which includes the following):
• Operator's Manual
• Bag of Quick Connect Spray Tips (4)
• Hardware Kit (which includes):
• Handle Bolts (2)
• Plastic Knobs for Handle (2)
• Carraige Bolt
• Plastic Knob (2)
• Tree Clips (4)
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 6. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly
before operation:
1. Attach handle and billboard.
2. Connect PerfectMix siphon tube to pump.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.

ASSEMBLY

6. Connect water supply to pump.
7. Attach spray wand to spray gun.
8. Select/attach quick connect spray tip to spray wand.
Attach Handle and Billboard
1. Place handle (A) onto handle supports connected
to main unit. Make sure holes in handle align with
holes on handle supports.
A
2. Insert handle carriage bolts (B) through holes from
inside of unit and attach a plastic knob (C) from
outside of unit. Tighten by hand.
NOTICE By loosening both knobs to the middle
section of the attachment bolt, the upper handle can
fold forward to store flat atop the cold engine. DO NOT
fold the handle down while the engine is hot.
3. Place billboard (D) over holes (E) on handle
(viewing from front of unit). Push the tree clips (F)
into the holes until they sit flat against the billboard.
4. Insert spray gun holder wireform (G) through hole
on handle and attach a plastic knob (H). Tighten by
hand.
H
7
B
D
F
C
E
G