Operation - Makita AN935H Instruction Manual

The trigger for single sequential actuation mode is
factory-installed. To change the nailing mode to contact
actuation, replace the trigger part with the one for con-
tact actuation.
1
► 1. Trigger for single sequential actuation (Gray
color) 2. Trigger for contact actuation (Black color)
1.
Turn the trigger lock lever to the lock position
► 1. Trigger lock lever
2. Push the pin securing the trigger from the ure-
thane washer side, and then remove the urethane
washer. Then pull out the pin and remove the trigger.
1
2
3
► 1. Pin 2. Urethane washer 3. Trigger
3. Set the trigger assembly for contact actuation.
With pushing in the hinged part inward, set the trigger
so that the hinged part is under the rod of the valve in
the housing.
2
.
1
► 1. Hinged part 2. Rod of the valve
4.
Insert the pin to the hole and secure it by urethane washer.
5.
Connect the air hose, and make sure that the
tool operates properly. Refer to the section "Checking
proper action before operation".
NOTE: To set back to single sequential actuation,
follow the procedures for changing the trigger above.

OPERATION

CAUTION:
Make sure all safety systems are in
working order before operation.
CAUTION:
When operating the tool, do not
close the face to the tool. Also keep hands and
feet away from the ejection port area.
CAUTION:
When not operating the tool,
always lock the trigger by turning the trigger lock
lever to the lock position
CAUTION:
Make sure that the trigger is locked
when the trigger lock lever is set to the lock position
Checking proper action before
operation
Before operation, always check following points.
— Make sure that the tool does not operate only by
connecting the air hose.
— Make sure that the tool does not operate only by
pulling the trigger.
— Make sure that the tool does not operate only by
placing the contact element against the workpiece
without pulling the trigger.
8 ENGLISH
1
2
.
.