Functional Description; Adjusting Depth Of Nailing - Makita AN935H Instruction Manual

Use a high pressure resistant air hose.
Use an air hose as large and as short as possible to
assure continuous, efficient nailing operation.
Lubrication
► 1. Pneumatic tool oil
Oil the tool with pneumatic tool oil by placing two or
three drops into the air fitting. This should be done
before and after use.
For proper lubrication, the tool must be fired a couple of
times after pneumatic tool oil is introduced.
FUNCTIONAL
DESCRIPTION
CAUTION:
Before adjusting or checking func-
tion on the tool, always lock the trigger by turning
the trigger lock lever to the lock position
disconnect the air hose from the tool.

Adjusting depth of nailing

This toll has the adjuster of the nailing depth. To mod-
ulate the nailing depth, turn the adjuster to the proper
depth.
► 1. Adjuster
The adjustable range is 8.5 mm (11/32"). (One full turn
allows 1.25 mm (1/16") adjustment.)
1
, and
1
1
► 1. Too deep 2. Flush 3. Too shallow
Hook
CAUTION:
Always disconnect the hose when
hanging the tool using the hook.
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
CAUTION:
Do not hang the hook from the
waist belt. If the nailer accidentally drops, it may
result in misfiring and personal injuries.
The hook is useful for hanging up the tool temporarily.
The hook can be turned while pushing the bottom to the
desired angle.
► 1. Hook
Furthermore, this hook can be installed on either side
of the tool.
To change the installation position, remove the bolt with
a hex wrench. Install the hook on another side and then
secure it firmly with the bolt.
5 ENGLISH
2 3
1