Maintenance; Removing Jammed Nails - Makita AN935H Instruction Manual

1
► 1. Ejected linked sheet

Removing jammed nails

CAUTION:
Always lock the trigger by turning
the trigger lock lever to the lock position
disconnect the hose before removing jammed
nails. Also remove the nails from the magazine
before cleaning a jam.
1. Depress the latch lever and open the door. Open
the magazine cap and remove the nail coil.
2.
Insert a small metal rod into the nail ejection port
and hit it with a hammer lightly.
3
► 1. Metal rod 2. Nail ejection port 3. Hammer
3. Remove the jammed nail with a flat-blade screw-
driver or other similar tool.
4. Reset the nail coil and close the magazine cap
and the door.
, and
1
2
11 ENGLISH

MAINTENANCE

CAUTION:
Before attempting to perform
inspection or maintenance, always lock the trig-
ger by turning the trigger lock lever to the lock
position , and disconnect the air hose from the
tool.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Cleaning of tool
Iron dust that adhere to the magnet can be blown off by
using an air duster.
1
► 1. Magnet
Storage
When not in use, disconnect the hose. Then cap the air
fitting with the cap. Store the nailer in a warm and dry
place.
► 1. Cap
Maintenance of compressor, air set
and air hose
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool,
it may result in poor performance and possible tool
failure.
1