Prime Security PrimeStart 650 Installation Manual page 15

1. Use a voltmeter to locate the wire(s) that show +12 volts while the ignition
key is in the "ON," "CRANK" and "RUN" positions and 0 volts when the
ignition key is in the "OFF" position.
2. Connect the 18 and 14 ga PINK wires to the vehicle ignition wire.
3. If the vehicle has a second ignition wire, connect the other 14 ga wire.
Heater/AC
The satellite relay module has one onboard 30-amp relay. Most vehicles have
only one heater/AC wire. If additional heater/AC wires are required to activate
the vehicle's heater/AC system, an additional 30-amp relay must be added.
Do not use the GRAY wire to power more than one heater/AC wire.
1. Use a voltmeter to find the wire(s) that show +12 volts when the ignition
key is in the "ON" position, 0 volts while the starter is cranking and +12
volts while running.
2. Cut this wire in half. Start the vehicle and turn the blower switch on. The
blower should not turn on.
3. Connect the GRAY wire to the heater/AC wire.
Starter
I
WARNING: Review the "Safety Bulletin" and diagrams on pages
14-16 prior to installing the starter system.
1. Use a voltmeter to find the wire that shows +12 volts while the ignition
key is in the "CRANK" position only and 0 volts while the key is in the
"OFF," "ON" and "RUN" positions.
2. Cut the wire in half. Test by trying to crank the starter with the ignition
key. If it will not crank, you have the correct wire.
3. Connect the YELLOW wire to the ignition switch side of the starter wire.
4. Connect the VIOLET wire to the starter solenoid side of the starter wire.
PrimeStart 650 Installation Manual
13