Table of Contents
Advertisement
Control Unit
1. Select a location under the dash that will allow you to use the tie wraps to
securely fasten the control unit.
2. Mount the control unit as high as possible to ensure maximum security.
3. Do not mount the control unit near moving parts.
4. Avoid areas that are in the direct path of air blowing from the vents.
5. Route wires from this point, leaving slack for ease of service.
RangeMaster™ Super Heterodyne Receiver Module
1. Plug the receiver module WHITE connector into the control unit WHITE
plug.
2. Use tie wraps to fasten the receiver module as far from the control unit as
possible.
3. Route the antenna cable behind the driver side windshield pillar, above
the headliner and behind the rear view mirror.
4. Fasten the antenna to the windshield with the attached adhesive tape.
Attach the antenna vertically so that the rubber tip on the end of the
antenna is facing downward.
Wireloom
1. Plug the wirelooms securely into the control unit and satellite relay
module.
2. Route wires from the control module and satellite relay module directly to
each connection point.
3. Separate the small and large RED, RED/WHITE, BLACK, TAN, VIOLET
and WHITE/GREEN wires.
4. Sleeve these wires with vinyl tubing or electrical tape and route them
through an existing rubber grommet into the engine compartment.
5. If an existing grommet is not available, drill a hole and install a snap
grommet.
8
PrimeStart 650 Installation Manual
Installation Procedures
Advertisement
Table of Contents
