Maintenance; Regular Cleaning - LG WT7850H A Series Owner's Manual

MAINTENANCE

WARNING
To reduce the risk of fire, electric shock, or injury to persons, read this entire owner's manual,
including the Important Safety Instructions, before operating this washer.
• Unplug the washer before cleaning to avoid the risk of electric shock. Failure to follow this warning
can cause serious injury, fire, electric shock, or death.
• Do not use volatile substances (benzene, paint thinner, alcohol, acetone, etc.), abrasive cleaners,
or detergents with strong chemical components when cleaning the washer. Doing so may cause
discoloration or damage to the machine, or may cause a fire.
• Certain internal parts are intentionally not grounded and may present a risk of electric shock
only during servicing. Service personnel-do not contact the following parts while the appliance is
energized. : pump, motor, noise filter cover, and heater (on applicable models).

Regular Cleaning

Care After Wash
After the cycle is finished, wipe the lid (door) and
the inside of the lid (door) seal to remove any
moisture.
• Leave the lid (door) open to dry the tub interior.
• Wipe the body of the washer with a dry cloth to
remove any moisture.
Cleaning the Exterior
Proper care of your washer can extend its life.
Lid (Door):
Wash with a damp cloth on the outside and inside
and then dry with a soft cloth.
Exterior:
• Immediately wipe off any spills.
• Wipe with a damp cloth.
• Do not touch the surface or the display with
sharp objects.
Care and Cleaning of the Interior
• Use a towel or soft cloth to wipe around the
washer lid (door) opening and lid (door) glass.
• Always remove items from the washer as soon
as the cycle is complete. Leaving damp items in
the washer can cause wrinkling, color transfer,
and odor.
• Run the Tub Clean cycle once a month, or more
often if needed, to remove detergent buildup and
other residue.
Cleaning the Tub
Over time, residue may build up in the tub, leading
to mildew or a musty odor. Run the Tub Clean
cycle monthly to remove residue and prevent
odor. Run the cycle more often under heavy use
conditions or if odor is already present.
1
Remove any clothing from the tub.
2
Add cleaning agents.
Cleaner
Tub cleaner
Follow manufacturer's
recommendations.
Lime scale remover
Liquid chlorine Add to main wash liquid
bleach detergent dispenser.
Follow manufacturer's
Powdered cleaner
recommendations.
Place directly into washer
Cleaning tablets
tub.
• For other tub cleaning products, follow the
cleaner manufacturer's instructions and
recommendations.
• Do not exceed the maximum fill line when
adding bleach or powdered cleaners.
Powdered cleaners may remain in the tub
after cleaning.
3
Close the lid (door) and press the Power button
to turn the washer on.
4
Turn the knob or press the cycle buttons to
select the Tub Clean cycle then press the
Start/Pause button to begin the cycle.
5
After the cycle ends, open the lid (door) and
allow the tub interior to dry completely.
MAINTENANCE 37
Instructions