Entering A Code; To Drive Your Car - Clifford BlackJax 5 Owner's Manual

entering a code

To enter your code, press the
times on the PlainView 2 switch, followed by the
a zero, you simply press the
EXAMPLE 1: To enter the factory set code of 2, you would press and re
lease the switch in this manner:
EXAMPLE 2: To enter a code of 1230, you would press:
,
,
,
and then

to drive your car

Until you set your own PIN code, you will use the factory set code of
"2." To drive your car, do the following:
1. Shut all doors, then start the engine.
2. Enter the factory-set disarming code of 2:
(not recommended that you do this while driving).
3. The dashboard LED will flash on for an instant to confirm proper code
entry. You may now drive or continue driving the vehicle.
8
button the appropriate number of
button.
,
–(1),
, –(2),
, , –(3),
–(0).
button. To enter
, and then .
, , and then