Chamberlain 8355W Manual page 30

Belt drive / chain drive
Hide thumbs Also See for 8355W:
Table of Contents

Advertisement

Adjustments
2 Test the Safety Reversal System
Without a properly installed safety reversal system, persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage door.
• Safety reversal system MUST be tested every month.
• After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST
reverse on contact with 1-1/2" (3.8 cm) high object (or 2x4 laid flat) on the floor.
TEST
1. With the door fully open, place a 1-1/2 inch (3.8 cm) board (or a 2x4 laid flat) on the floor,
centered under the garage door.
2. Press the remote control or wall-mounted door control to close the door. The door should
stop and reverse when it makes contact with the board. The door returns to the previous
open position. Opener beeps and lights flash 5 times.
3. If the door reverses, remove the board. The test is complete.
If the door stops but does not reverse:
1. Review the installation instructions provided to insure all steps were followed;
2. Refer to Adjustment Step 1 and and set the down limit closer to the garage floor. NOTE: On a
sectional door, make sure adjustments do not force the door arm beyond a straight up and
down position.
3. Repeat the Safety Reversal test.
If the test continues to fail, call a trained door systems technician.
1
2
3 Test the Protector System
Without a properly installed safety reversing sensor, persons (particularly small children) could be
SERIOUSLY INJURED or KILLED by a closing garage door.
1. Open the door. Place the garage door opener carton in the path of the door.
2. Press the remote control push button to close the door. The door will not move more than 1" 
(2.5 cm), and the garage door opener lights will flash 10 times.
The garage door opener will not close from a remote control if the LED in either safety reversing
sensor is off (alerting you to the fact that the sensor is misaligned or obstructed). If the garage door
opener closes the door when the safety reversing sensor is obstructed (and the sensors are no more
than 6" [15 cm] above the floor), call for a trained door systems technician.
1
30
®
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

8355w-2678360w8360wl8360wlb8365w-2678365w

Table of Contents