Table of Contents
Advertisement
14
www.electrolux.com
●
No Spin (
No spin option eliminates all the spin
phases and increase the number of
rinses.
●
Rinse Hold (
By selecting this option the water of
the last rinse is not emptied out and
the drum turns regularly to prevent the
laundry creases.
The door is still locked to indicate that
the water must be emptied out.
Select "
ON the sensors for the dirt and detergent
residue.
The "SensorWash" is switched ON
by default. If you want to turn OFF
the sensor press this touchpad
once. (Please see the table
"Program Options Compatibility"
for which programs can be used
with this option.)
When using this option, machine will
automatically check the dirt level and
detergent residue in your laundry. It will
automatically adjust the washing time
and numbers of rinses according to the
load to make sure that your clothes are
really clean.
The SensorWash technology consist of 2
different sensors for detection:
1) The 1
dirt level at the start of cycle and
automatically calculates the actual
time needed to remove the level of
dirt in the wash; from low dirt levels
all the way to the maximum dirt level.
)
)
The door stays locked with the
water in the drum. To continue
the cycle, you must press
(Start/Pause).
(
) Touchpad
" option to turn
st
Turbidity sensor detects the
The initial time displayed on
the control panel indicates the
time needed for the maximum
dirt level.
nd
2) The 2
Conductivity sensor will check
the amount of detergent residue after
the first rinse and the machine will
calculate the optimum number of
rinses (Maximum of 2 additional
rinses) needed to make sure that the
detergent residue is properly removed.
Please see details of detergent
usage at "Detergents Type and
Quantity of Detergent"
Vapour (
) Touchpad
Select this option to add approximately
30 minutes of tumbling in vapour during
the wash cycle. Vapour helps open fabric
fibers up to allow laundry additives to
release tough stains. The indicator of this
option will be on.
●
Vapour may not necessarily be visible
inside the drum during a vapour wash
cycle. Vapour is created below the
drum and allowed to naturally rise into
the clothes.
●
Vapour may not be present during the
entire vapour wash cycle.
●
Vapour function is more effective with
half load.
●
At the end of the Vapour cycle, the
clothes will be warmer, softer and
detached from the drum.
NOTE
If Vapour option is selected, rinse
temperatures will be elevated.
During a vapour cycle, you may notice
vapour exiting from the drain hose of
the Wahser-Dryer, this is normal and
there is no cause for alarm.
Advertisement
Table of Contents
